8085 INTERFACING WITH 8255 PDF

Problem – Interface with microprocessor and write an assembly Subtract content of two ports by interfacing with microprocessor. The interfacing happens with the ports of the Microprocessor. The main IC’s which are to be interfaced with are: 1. PPI. 2. PIC. 3. USART. PPI: 82C55 The 82C55 is a popular interfacing component, that can interface any TTL-compatible I/O device to the microprocessor.

Author: Arashihn Aragore
Country: Slovenia
Language: English (Spanish)
Genre: Life
Published (Last): 9 July 2004
Pages: 393
PDF File Size: 10.40 Mb
ePub File Size: 8.95 Mb
ISBN: 892-6-47057-322-6
Downloads: 15181
Price: Free* [*Free Regsitration Required]
Uploader: Dukinos

Memory mapped I/O interfacing with 8085 microprocessor

In serial communication interface, interfading interface gets a single byte of data from the microprocessor and sends it bit by bit to other system serially or the interface receives data bit by bit serially from the external systems and converts the data into interfacijg single byte and transfers it to the microprocessor.

These buffered lines are connected in parallel to all display digits. Timers and Counters in Microcontroller. A programmable device can be set up to perform specific function by writing a code in the internal register. Mask bit B3 to B7.

  BERTRAND RUSSELL ENSAYOS IMPOPULARES PDF

Microprocessors engineering – Interfacing the 8085 microprocessor

Now how to select between the two devices according to the requirement? Block Diagram of Programmable Interrupt Contr Send data on PA to glow R1 and R2. Initialize lookup table pointer. Interfacijg interface gets a byte of data from microprocessor and sends it bit by bit to the other systems in simultaneous or parallel fashion. This current is required to produce an average of 10 mA per segment as the displays are multiplexed.

interfacing – Microprocessor Course

In simple words, the primary function of a memory interfacing circuit is to aid the microprocessor in reading and writing a data interfaacing the given register of a memory chip. Wait for the interrupt. Other blogs of mine: Dont use any Interrupts. Motor can be rotated in steps by giving proper excitation sequence to these windings. Interfacing Types There are two types of interfacing in context of the processor.

Looking forward for your comments and suggestions Minimum Mode Configuration of Initialize in write display RAM mode. Actual pin connections are listed in Table 1 below. Only lower data bus D 0 — D 7 is used as is 8-bit device.

  CASTLE FALKENSTEIN RPG PDF

Initial size in write Display. The electric bulbs are controlled by relays. The peripheral devices includes.

But the main disadvantage with this interfacing is that the microprocessor can perform only one function. The traffic should be controlled in the following manner. For this circuit different addresses are: Jump back to read status. Interface an 8 x 4 matrix keyboard to through If not zero repeat.

The interface also receives data bit by bit simultaneously from the external system and converts the data into interfacint single byte and transfers it to microprocessor. It functions as an input device if it is connected to buffer and as an output device if it is connected to latch. Interrupt Structure of There are two ways in which a microprocessor can connect with outside world or other memory systems.

Interfacing of with Programmable peripheral devices were introduced by Intel to increase the overall performance of the system.