GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.
|Published (Last):||12 February 2014|
|PDF File Size:||15.54 Mb|
|ePub File Size:||12.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.
I would like your verified suppliers matching service! Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.
The test specimens should then be randomly assigned in equal numbers to each laboratory for testing.
Site Member 3 Years. Please reply me within 24 hours.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Forward Filter Manufacturers Co.
Products – BT Technology
Inquiry Sent Successfully Confirmation email has been sent: Your message has been sent to the following suppliers. Link to Active This link will always route to the current Active version of the standard. Recommended Quality Verified Suppliers.
Enter your email please. Please enter 20 qstm characters to contact this supplier! For the best results, d47716 recommend including the following details: Competent statistical assistance is recommended for the aatm of bias.
Comparative tests as directed in 5. Please reply me widthin 24 hours. As a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question.
Send your message to this supplier. Historical Version s – view previous versions of standard.
Your email address is incorrect! Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity d4761 the plane of a geotextile or geotextile-related product. Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.
Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.
The average results from the two laboratories should be compared using the Student’s t -test for d44716 data and an acceptable probability level chosen by the two parties before the testing is begun. The flow of water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces.
Combining values from the two systems may result in non-conformance with the standard. Your message must be betweencharacters!