GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.

Author: Akinole Tugrel
Country: Uganda
Language: English (Spanish)
Genre: Career
Published (Last): 4 October 2011
Pages: 446
PDF File Size: 6.10 Mb
ePub File Size: 7.51 Mb
ISBN: 433-7-75038-920-4
Downloads: 68223
Price: Free* [*Free Regsitration Required]
Uploader: Mimi

Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. Send your message to this supplier.

Historical Version s – view previous versions of standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. d7416

Products – BT Technology

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Your email address is incorrect! Recommended Quality Verified Suppliers. Please enter 20 to characters to contact this supplier!

Combining values from the two systems may result in non-conformance with the standard. Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.


I would like your verified suppliers matching service! For astmm best results, we recommend including the following details: Your message has been sent to the following suppliers. Your message must be betweencharacters! Comparative tests as directed in 5. Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.

Site Member 3 Years. Competent statistical assistance is recommended for the investigation of bias.


The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Please reply me within 24 hours. Link to Active This link will always route to the current Active version of the standard. Please reply me widthin 24 hours.


Inquiry Sent Successfully Confirmation email ast been sent: Enter your email please. The flow of water within the plane of a geotextile or geotextile-related product is measured under varying normal compressive stresses, with typical hydraulic gradients and with defined contact surfaces.

If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree d416 interpret asstm test results in light of the known bias. V4716 a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that are formed from a lot of the material of the type in question.

Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product. Forward Filter Manufacturers Co. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.