Channel radio control system instruction manual • Read online or download PDF • Futaba 3PK User Manual. View and Download FUTABA 3PK instruction manual online. 3-CHANNEL RADIO CONTROL SYSTEM. 3PK Remote Control pdf manual download. View and Download FUTABA 3PKS instruction manual online. download. Also for: Magnum 3pk super. Remote Control FUTABA 3PK Instruction Manual.
|Published (Last):||27 August 2012|
|PDF File Size:||9.51 Mb|
|ePub File Size:||13.59 Mb|
|Price:||Free* [*Free Regsitration Required]|
Channel Servo position setup: Futbaa the wheel unit wiring harness 2. This is a mechanical stop screw only, and does not move the neutral point or affect the acceleration pull side of the throttle trigger.
Channel 3 position “CH3” 3rd channel system The channel 3 servo position can be set from the transmitter. Install the adapter cover, wheel, and wheel cap in same using four 2. Don’t have an manaul Reverses the direction the servo moves when given an input. An up timer and down timer are also provided.
When CH3 is assigned to a dial by fuatba dial function p. This may be adjusted individually for turning and returning the servo to neutral steeringand for high and low throttle settings.
Level lv3 only servo view servo – Futaba 3PK User Manual
The setting is stored within the programming and the onscreen displays continue to show neutral. If it does not, the system is ready for use. Use idle-up to increase the idle for starting only. Warning Displays Tone will sound 9 timesthen repeat. Do not bundle the receiver antenna wire together with manial motor controller lead wire. Don’t show me this message again. Servo Reverse “rev Servo Reverse futaa All channel This function reverses the direction of operation of the servos related to transmitter steering, throttle, and channel 3 operation.
Traditionally, dual rate on a car radio is used to describe a single rate that can be adjusted while driving.
Futaba 3PK 2.4GHz User Manual – Download
When using an FM receiver e. Table of Contents Add to my manuals Add.
Futaba has notified Horizon Hobby that they will be handling their North American Distribution themselves in addition to some small regional distributers. Regular stop watch timer. Device used to read the manuaal voltage of the on-board battery pack or transmitter battery pack.
Counts negatively once desired time is passed below 0. Use this function when a mechanical off- set has occurred for some reason. Model names may be the same between models; model will still be displayed and will still be different.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. When you want to decrease the servo travel, adjust the — Copies all settings, including model name, modulation, etc.
Battery Replacement att ery cover 1. Keep the receiver antenna wire at least 1cm away from motor, battery, and other wiring carrying heavy current. Dual Rate, or Primary Dual Rate: Slide the battery cover back onto the transmitter.
Pdf Download | Futaba 3PK GHz User Manual (2 pages)
Futaba has made the decision to establish their own service and nanual operations in the US. Channel 3 Position “ch3 Channel 3 position “CH3” futbaa channel system The channel 3 servo position can be set from the transmitter. Used to replace the longer stock antenna. When ending setting, return to the initial screen by pressing the END button twice for direct selection, press the END button once. It is normal for the module to get slightly warm during use.
If you continue to use the system, the transmitter may manuwl and cause loss of control Model Select Error If the power is turned back on in the state in which a model No.
Page 7 It is normal for the module to get slightly warm during use. Adjust steering dual rate ST-DR: The method of connecting the motor controller to the motor and battery depends on the motor controller used.
The race time and audible alarm can be set.