Find the user manual and the help you need for the products you own at ManualsOnline. I got an old laptop model MA2 without powersupply. SetIP command to see and change the IP addresses of the console. This command can be used to change both Ethernet connectors and even set a gateway. Requirement: STP (shielded twisted pair) cable with RJ45 connector, min. Cat 5e . To connect Ethernet port 1: Connect one end of an Ethernet cable to the.

Author: Kazrara Brarisar
Country: Gambia
Language: English (Spanish)
Genre: Software
Published (Last): 13 January 2006
Pages: 178
PDF File Size: 3.35 Mb
ePub File Size: 16.9 Mb
ISBN: 269-4-31108-401-2
Downloads: 21871
Price: Free* [*Free Regsitration Required]
Uploader: Dugami

After getting the same problem with a different motherboard, knowing it was a grounding issue. That was a post from when I started.

Connect Ethernet

I would like to know to where you jumped it? Luckly I took an electronics course and did a ton of soldering on new boards.

Mayo Hardware Sat Jun 12, Anonymous Sun Agteway 02, First the seems to be mounted upside down? Any thoughts on this? This is usually caused by poor soldering, or pads not flowing through to bottom side. I found your blog a few days ago while looking for a solution to the MA7 power problem.


The break or crack is virtually impossible to see with the naked eye. If I forget send a reminder in a couple of days. When payday rolls around, I think mamual a good bet it’s getting the battery Or remove battery and wait a couple of hours.

BTW the system will post off battery power. So if they replaced the DC jack with a new one that would fix it?

I can’t seem to figure out what is wrong with this gateway ma2

Really no trick for testing the battery but most of the Gateway MA series batteries have a AO inside. As soon as I disconnect the external monitor I loose power. I see PQ29 markedis this it or are there others?

The AC plug would require much wobbling and pinning in a specific location to allow the unit to run. This is because I have not had experience on every motherboard that is out there.

gateway ma2 upgrades Computers & Internet Questions & Answers (with Pictures) – Fixya

Though you gave no description of your problem I cannot guess where your problem might be. If that is OK then you will need to check the AO see if it shorted. Ken Sun Aug 15, Newer Post Older Post Home. M2a topic as PDF Version 3. I went to a technician and he kept saying if i want i could trade it in and buy a dell he has at a cost.


One picture shows the scorching under the copper, the other shows the current path of the DC In. Stuck windows vista business on it.

I personally have never experienced that problem, but surely it is the reason. Your name or email address: Damien Sun Apr 25, And the solder looks good on the motherboard. I cant make out manuql code on the chip as its blown off. Sorry for the delay- I am new at blogging, and was attempting to put info out the best I could.