Correction in Service Manual. CX New camera body – new parts .. The operation (except ELX) is fortunately a matter of minutes only. Digital Camera Hasselblad ELX Instruction Manual Camera body ELD Disassembly To remove the parts from the outer and inner The Adobe Acrobat Reader allows you to view and print Hasselblad Historical documents in PDF format. A free copy of the Acrobat Reader is available from.

Author: Zulkikinos Malataxe
Country: Cyprus
Language: English (Spanish)
Genre: Health and Food
Published (Last): 24 July 2005
Pages: 285
PDF File Size: 18.55 Mb
ePub File Size: 7.62 Mb
ISBN: 815-8-47422-132-5
Downloads: 29494
Price: Free* [*Free Regsitration Required]
Uploader: Shaktigrel

At this point, have an assistant press the lens release button and try to remove the lens from the body. Your first reaction is to try to wind the body. There is a way, however, to “fingerprint” your magazines. It repaur return to its normal operating position, and the diaphragm blades should open all the way. What is the proper way to load film in an older style Magazine 12, 16 or 24?

Hasselblad 555ELD Service Manual

While you hass,eblad watching this happen, check to make sure that none of the shutter blades are broken or appear to be out of place. Why did you replace my dark slide? Hasselblad cameras and lenses are designed so they perform properly with little or no special precautionary measures.

It also includes all the part numbers. At that point, lift the transport key again and wind it through at least six or seven turns to wind up the backing paper trailer before opening the magazine and removing the em. Then charge the battery for 14 hours, and it will be fully charged.


500 EL/M won’t fire with pressing of release button

This applies to storing cameras and lenses over extended periods of time, so there is no need to fire the cameras or “trip” the lenses before storing them. Page 14 Camera body ELD Disassembly Right and left hand wall Remove or cut the foam plastic pad to get access to the screws Secure the stop armby refitting the bearing pinthe eccentricthe small nut and secure by the clip As the shutter blade ring moves back and forth, the shutter blades open and close.

Proceed using the following sequence: But have you checked the thing? This is done by turning gear But there was another problem.

Hasselblad repair manuals by Dick Werner

As you wind the body, the body gear winds this magazine gear, which, in turn, advances the film. If the upper left hand corner of the dark slide is bent, it might not activate the release button blocking arm, which would prevent the film back from attaching to the camera body, or could prevent you from removing the film back from the camera body once it is on. What should I do? The larger screw on the right is the screw that holds the front key cover in place.

It is not uncommon for a crack to appear in a blade. That means it’s trying to work but is being held up mechanicallyspeakingwise.

  TDA7342 PDF

While you are holding it in, check to see that both of the rear flaps are opening all the way. The new brake assembly was a vast improvement over the original brake, but problems started to develop. So the majority of EL Does anyone out there know how I could go about fixing this without having someone repairr myself tear down the camera to adjust the release lever?

Camera body ELD Adjustment Checking the databus connections Check the integral control connector to ensure hassleblxd and direct communication between camera body and digital back. Not a pleasant experience at all.


Camera body ELD Disassembly Mirror Disconnect the mirror hinge from the two pins “A” and release the pin “B” on the mirror frame, from the mirror lever EPS Refit the gearwheel temporarily.

Check each of your lenses using this procedure. This manual contains 98 pages and is a photocopy of the original.

Remove the lens and magazine. If this happens, the front key assembly will have to be replaced, and this is a very expensive part. The first manuaal on the body gear, which used to go into the opening in the magazine gear, hits the first tooth in the magazine gear.

The manual is illustrated with 17 photos and covers the following:.