DRAWING. Winstar Dot Matrix LCD Display Module 16×2, LCD Display A – WHA. SPECIFICATIONS. WHA LCD Datasheet. Interface Pin Function . This tutorial shows how to connect the A LCD display and a light sensor to your Arduino (UNO) and display the light intensity on the. CL Electronics. The Netherlands email: [email protected] com. Datasheet. Type: LCDB. Rev.: V
|Published (Last):||16 October 2007|
|PDF File Size:||4.21 Mb|
|ePub File Size:||13.88 Mb|
|Price:||Free* [*Free Regsitration Required]|
ITMA Datasheet, PDF – Datasheet Search Engine
I choose to solder the connectors to the back so I could press the LCD display on the breadboard. Works like an absolute charm! Finetuning gets a little harder because the range is bigger, but that’s no problem for this tutorial. Connecting the display and breadboard First you need to power the display and its backlight.
But it works anyway! Just mention the resistor value for the light sensor again when you deal with it, it is mentioned in the beginning,but I missed it first time around,excellent tutorial: Frank M 25 April Did not specify resistor value? Also there are many different versions of the LCD display with different pinouts and I couldn’t really find which the DX version exactly was. This way you can solder wires to it, solder a connector on it, whatever you want.
Vasilis 03 December you made my day. Did not specify resistor value? Next up is the pot meter. This website is his personal playground which changes almost every day. Plug the pot meter in the breadboard, somewhere left of the LCD display and connect the three pins.
New on Dreamdealer Behind the scenes: Johan is a professional frontend developerpetrolhead and allround DIY-er.
Dot Matrix LCD Display Module 16×2
I put in a 1K resistor. Ming 26 July Very Good Tutorial! Worked on my first attempt. Puzzled me that the lightSensor reading was higher in the dark, but now I get it.
If your vatasheet looks like this, you’re doing fine: Basil 05 April Thanks a lot for the explanation, Great work! It’s only only used to display your Gravatar image!
The tutorial is simple for all to understad and get started. I am using only parts from the Arduino starter kit I got from Deal Extreme. Moses Lakra 04 November A good tutorial. We use the potmeter to set the contrast of the display.
Dot Matrix LCD Display Module 16×2, LCD Display A, A LCD Datasheet – WHA
Your mail is safe with me. Kevin 04 September Works like an absolute charm! In the next few steps we’ll connect the display further to the Arduino to let the arduino communicate with the LCD screen and put some characters on it. About the author This post was writen by Johan van Tongerencreator of this website.
To do this, snap of a daatsheet of connectors 16 pieces and stick them short pin up trough the LCD display connectors. Of you don’t see them, turn the pot meter slowly from left to right to adjust the contrast.
Michael Bean 14 December Excellent!!! You can finetune this setting when we’ve got datashet on the display later. CSS-only Clock Intelligent image cropping with focal point image-rendering: I was trying other codes but could not get success.
Stick the Datasheeg display in the breadboard, somewhere on the right in the lowest row of holes so you can connect the breadboard wires above and the display rests on the unused rows of the breadboard.