This user manual will explain to you how to install a motorised installation with a motor ref: Such installation needs some operations, on the motor, but. Please watch the video above then follow the following steps carefully to get your motorized system installed quickly. If you have any questions, visit our forums. Setting Up a Dish And Motor. How does a dish and Motor work? A dish and motor setup needs at least a 27 inch dish we recommend at least a 33 inch dish and.

Author: Dourr Yozshubei
Country: Oman
Language: English (Spanish)
Genre: Music
Published (Last): 11 February 2004
Pages: 21
PDF File Size: 9.92 Mb
ePub File Size: 20.8 Mb
ISBN: 853-6-32791-937-6
Downloads: 11627
Price: Free* [*Free Regsitration Required]
Uploader: Tygot

Compatible with the following controllers. Use extreme caution when installing or removing an outdoor antenna that is located close to overhead wires.

STAB | USALS (Universal Satellite Automatic Location System)

Set the elevation angle on the motor – the elevation angle on the motor will be based on the latitude of your location. With these data and following the instruction manual, everyone can install a STAB rotor system. Attention and Warning Symbols You must be aware of safety when you install and use this system.

You simply disconnect the cable from the LNBF. How to Align a Satellite Dish. The mounting hardware in this kit is.

Tighten all coaxial cable connections on the motor only by hand. HH Motors are usually set to zero degrees by default from the factory. Step by step guide to installing your own Ku Band satellite dish If you don’t feel comfortable installing your own system, your insallation TV Aerial or Handyman can easily installwtion these helpful guidelines for.


Approximate Dish Elevation Angles for Ireland. What could cause a HH motor not to operate properly?

Atlantic Bird – The VSAT system consists of the following hardware: You need to find the satellite that is nearest to degrees on a compass setting.

The antenna shall More information. To make this website work, we log user data and share it with processors. The motor gets its power from the receiver using the same coaxial cable running from the receiver to the LNBF on the dish. Disconnect SUB-D connector from. Most diseqc motors use a special adjusted declination angle formula based jsals the tilt of the rotating motor shaft which will again be specified in your manual.

See users forum and post your question there: By following the above instructions accurately, you should now have installed your dish on the arc.

If you have a different model of motor, it will use a different formula for the adjusted declination angle. Let s have fun with your Performer. Perform a Power Scan this will wity update the transponder in your receiver. Dish might be too heavy for the motor to handle. For example, Athlone, which has a latitude of 53 degrees, will require an elevation angle of 36 degrees.


When the motor stops, check the signal meter on your TV screen. Assembling Toroidal Thanks for choosing Toroidal.

Well, by adding a motor to your system you will be able to receive satellite channels from several satellites instead from one only. Attach the Diseqc motor to the pole – tighten the motor fittings.


Such damage is not covered by any warranty. Coax is not connected correctly to motor or receiver Cable is too long over 75ft There is a bad connector or short in connector Motor needs to be reset to the Zero usalx.

Just set the skew at 0 and the motor will tilt the whole dish when it moves. Where can I find out what channels are available free to air? Marks a procedure where the following may happen: Therefore we recommend to follow the features below: The tripod supports the Integrated Sensor Suite.

The following diagram will help you to locate any faults. Wait 10 to More information. When you get the maximum quality, tighten the motor on the mast. Peak the signal on the meter for the farthest Eastern satellite in the horizon until you believe it is as good as you can installqtion by moving both east and west.

So for Athlone the adjusted declination angle is 23 degrees i. T his angle should be equal to the latitude value of the motpr location.

Posted in Sex